![]() ![]() Then type "$$" + Return to see the settings in the board.Īll settings are permanently stored in the board. Use a simple terminal program 115KBaud and connect to the controller. It is set by default after installed the latest GRBL on a board. If you don't have any endstop switches, the motor drives against the mechanical limit endless.Ĭheck the GRBL settings in the board. The noise could be a function to drive all axis to the home position. The controller board must run GRBL without any bootloader to avoid thisĪnother way to avoid the problem is switching on the laser after connecting to host. This has nothing to do with the software here. The laser goes on to full power because the bootloader in the control board sets all outputs high while running the bootloader routines.Īfter 2 seconds or so, the laser goes off again. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |